PunisheR YotA

OK, it has been some time now and i haven't posted anything.
well here is what has been done.






not super high lift but im not going for that. just anuf to make a difference. ad yea i went with a 2link, just because i want to.

not finished by farrrrr but it's progress. i still have to add back plates to bag brackets.
clean up a lot of the wiring and hose routing.
fill-in and clean up the frame to make it look good.
o-yea bolt in the bags instead of just setting them in there.

not much latly but it did get this done.

Don't know how well it will work but i seen this same set-up on a guys rat-rod so i fig. i would try it. if it doesn't work then i'll go with a reg. pan-hard bar setup.
BTW the shocks are not the ones that i will be using, they are there to make sure i have clearance. i'll prob. go with toxic shocks or something sim.
Them air shocks will be used to do my tilt bed.

worked on gas tank mount (boat tank)

went to the j-yard yesterday and pick up a wiper motor and some other odds and ends.
for some reason i cant find the wiper motor that i took off mine. i wonder if i accidentally installed it inside the motor block when i was putting it back together. if i did then it can just say there. I'm not taking it back apart to find out.....
also i pick-up some bolts and gas line from the part store to bolt up my bags and to run lines to the tank.
so i hope i can get time this weekend to put parts on....

My get done list is getting close to being done.... wooohooo

ok been thinking after the last post.....

Fig. I'd draw it up a little.

here's some crappy vids taken with my stupid phone.

ok i haven't been on here in some time so here's a bring it up to date post.

and with the bed down it looks stock.

here's a list of what all i think has to be done to call it finished for now, cuz it's never finished just finished for now. lol
1. running the rear air lines
2. wire up the switch box (Waylayed famous 3)
3. running new hot wires and grounds for pumps (old ones are to short now with the tilt bed)
4. new relays for the pumps (might as well with all the other new stuff added)
5. add some back supports for the rear bag mounts (not needed but i will feel better about it)
6. finish bolting up the f. grill
7. test and fix if needed lights and blinkers
8. paint all new brackets, gussets, mounts, and all other stuff on the back half to make look better
9. run air line to air horn
10. buy and install lift supports
11. repaint truck and Punisher skull (primer gray of course)
12. drag blocks (Waylayed titanium)
13. figure out what I'm going to do to it next...............

ok well i got the air system all worked out and works great.
runs good and now for some reason the headlight are not working.
so i fig it's something small so should be no biggy.
wont be long before i'll be cruising.