Tubular A arms

wat price r u gettin them 4

dont remember, low fives. think they went up right after i paid for em. still havnt got em tho, talked to steve today. he said week and a half or two...

he is not write back to any of my email, and is a little hard to call him from Australia

Loagz I'm not sure what to tell you. Steve sent me an e-mail about 3 hours after I sent mine. I just got put on the list and Steve should start on mine in a few weeks. Can't wait.

yeah, catch him on the phone bout 12:30pm EST whatever the hell than means in australia, usually when i get him. Be prepared to talk for awhile if you catch him, he likes to talk...

What all did you order? Just arms?

Yea I just ordered arms. I'm wanting to get a tranny x-member but I think I'm gona get it from you. Not sure though.

I'm hoping that the arms are the only thing I'm going to need to lay in the front. I don't really want to buy spindles to but I will if I have to to run 19s.

You can lay 20s on stock spindles. Plus the camber looks cooler IMO. Steve makes a nice crossmember, I've seen them and the quality is there. I just dont like that its straight. It leaves little room for exhaust, and puts the exhaust closer to the floor. Guess its just preference reallly. And I dont know how much his cost.

And, you will have to Z your frame to lay flat.

yeha i was just after a price coz i got mates that want them i need like 5 sets +

Hrm.......I might have to get yours then. I'll be putting my SBC in soon enough and am gona need all the room I can get for exhaust.

I don't really like all that camber. Expecially with a wide rim.

How much you reccomend I Z my frame?