pictures of a how to flip balljoints

ok well i want to go ahead and do this today.. i was wondering if anyone has any how to pics.. cuz i dont know wtf i am doing.. lol
any help would be great.

also.. is this very bad on the truck?

I haven't had any problems yet.

First, take the balljoints off. Knock the studs out. Mine were just pressed studs, and a few blows with a hammer took them out. Then, there is a 'bubble' on top of the arm. This, and the surrounding area needs to be removed. Basically anything that is in the way. This is the only picture I have of my arms comparing them. I don't have ony pictures of them stock.

thanks.. im gonna go do it. i guess i will take a camera to show the b4 and after, of how it sits..

When I flipped mine for a day or so while bagging the front, I only flipped my Uppers.. just unbolt the plate, move to underside of control arm rather than top of it.. bolt back, real simple.

I got like a 3/4" drop. I didn't change anything on my uppers, because they were already on top.

Yea i might have said that backwards, i just know i moved them to other side of the control arm lol.

ok i moved them from the underneath of the upper arms to the top of the upper arms... should i do the same with the lower control arms??

i also started mono leafing the rear end too, but it got too fuckin dark.. lol
will be finishing it up on sunday

also.. is it bad for me to remove the torsions? to do that, do i just take the nuts all the way off?
my front wheels are barely tucking