a arms

No, I have factory uppers already. I actually have an entire clip to test them out on, and see how big of a wheel I can make them lay on. Basically I want to build them to be maxed out on a 27" tall tire, so anyone can bolt them on and lay any size 20 with drop spindles. Which should also lay an 18 on stock spindles, or still get good lift on 18s with drop spindles. I needed the factory lower bolts, because I didn't have any with the clip for some reason, and I needed one for the jig, but I ended up just ordering new M18x120mm G10.9 bolts for it. I do need to find a 23/32 drill bit through.

Stellar, I believe the stock arms are around 12 inches or so. I can't remember exactly.

Thanks Seth.

how are the arms comin along?

hey donny, any word from mike on ur arms, been about a month? just curious.

I'm working on it. I'm going to make a jig for the lowers first, I'm waiting on cross shafts to do the uppers. Probably takes a while to make 20 shafts.

lower arms measure 15 inches from longest point to longest point. I know this from them not fitting in the damn box when i went to ship them to seth...

Sweet! Thanks for the measurement.

Can't wait to see these arms.

I got the jig done for the lower arms just now. Just waiting for it too cool down enough to handle. Then I will start piecing together the first set of lower control arms. Maybe by tomorrow night I will have a finished set.

And the control arms are 14 1/16" from center of the bolt to the center of the balljoint pivot.

damn seth, you got a fucken pc in your garage? damn machine.... keep crankin that shit out bro, i'ma have another corona....

No I came inside for a soda. I'll have a computer at the shop once I move in there though.