Serious Control Arms Question

Can someone get me some buns to go with all that beef on those sd arms.

sorry man, we dont build em, i just deal for Kustom Werks, Top notch quality but from the looks of things SD has some DOPE arms on the way.

man i have the ART uppers and lowers and so far so good they are working great. no complaints here. if you need them right now right now and have the money go with the ART from jason @ SD. but by the looks at the SD line of uppers they are going to be bad aS$.

holy crap jason is gonna have a hard time with legalities on these arms, they might me construed as a WMD!!! (weapon of mass destruction) those things look like a deadly weapon they are soo huge.

Those BYC ones dont look that strong to me. The tubes should be notched and the balljoint plate welded into the notches for strength like the KW and SD ones. Looks like those SD ones are gonna be beefy as he!! MS

Originally posted by PAINTGUYEKS



Those BYC ones dont look that strong to me. The tubes should be notched and the balljoint plate welded into the notches for strength like the KW and SD ones. Looks like those SD ones are gonna be beefy as he!! MS

since when did you set the standard for arms? ive built several sets of arms and never felt the need to notch the tubing. and they have seen 1000s of miles.

mmm beefy

SUICIDE DOORS FTW!

speakin of beefy here's a 4 link bar i built for a friend, he was plannin on droppin some major HP in his mini and wanted a hella 4 link so he could cantilever and still run massive hp to the rear without breakin anything

Originally posted by bdroppeddak



Originally posted by PAINTGUYEKS



Those BYC ones dont look that strong to me. The tubes should be notched and the balljoint plate welded into the notches for strength like the KW and SD ones. Looks like those SD ones are gonna be beefy as he!! MS

since when did you set the standard for arms? ive built several sets of arms and never felt the need to notch the tubing. and they have seen 1000s of miles.

I didnt set the standard for arms and last i checked neither have u as far as i have seen. When i ran dirt latemodels all the arms had the balljoint plates sunk into the tubes, i guess all those manufacturers as well as KW and SD do it for looks ahhahahahahahahahahahahahahahhahaha

most dirt track cars in this area use threaded sleeves not bolt in ball joints, but either way a piece of 5/16 plate welded to 1/4" thick 1" or 1 1/4" DOM isnt gonna snap before the balljoint does. look at stock arms, they are just stamped pieces of 10 gauge.

the SD arms look real good

they're all the same to me, each just have their own look