Page 15 of 26
American Cars \ The Uni-body Drop has Started (New Pics pg 16)The Uni-body Drop has Started (New Pics pg 16)
views 5212
replies 254
following 101
LaidNeon
+1y
Edited: 1/27/2007 4:17:01 PM by CrucialNeon
After i got the Front Mounts from ARP, i went ahead & made the bag plate that bolts to the mount. My dad took my rear bag plates with him to work & had their shop guy tap my bar ends since i had no luck finding a 3/4" - 10 Tap. After i get them bag i finished cleaning up the welds so it would have a better & flusher look. I needed the ends tapped so i could bolt on the heim joints that will be mounted on the Pivot bar. I also started making the Pivot Bars that receives the Heim Joint. I ordered the thread bungs from suicide doors & then i welded them to some 1 1/2" bars. I'm also getting http://GuiltByDesign.net. They will be laser cutting me some brackets for the pivot bars. These plates aren't anything special so don't get your hopes up. They are a very simple, but importance design.
BEFORE
AFTER
After i got the Front Mounts from ARP, i went ahead & made the bag plate that bolts to the mount. My dad took my rear bag plates with him to work & had their shop guy tap my bar ends since i had no luck finding a 3/4" - 10 Tap. After i get them bag i finished cleaning up the welds so it would have a better & flusher look. I needed the ends tapped so i could bolt on the heim joints that will be mounted on the Pivot bar. I also started making the Pivot Bars that receives the Heim Joint. I ordered the thread bungs from suicide doors & then i welded them to some 1 1/2" bars. I'm also getting http://GuiltByDesign.net. They will be laser cutting me some brackets for the pivot bars. These plates aren't anything special so don't get your hopes up. They are a very simple, but importance design.
BEFORE
AFTER
LaidNeon
+1y
im workin on finishing up the cantilever & then i'll post up more pics. Hey seth, im getting with your guy to cut me some brackets too
LaidNeon
+1y
About 3 weeks ago i cut the FUCK out of my finger with my Grinder. Well its almost gone now & today im working on my Cantilever. I was using my grinder with the cut off wheel. I went to set it down & my dumb finger got in the way & i barely cut it. No biggie, well 30 min or so later im cleaning up some welds with my grinder & snagged the shit out of my finger again. Only this time it wasn't as bad as the first one.
The bits you see on the middle cut are chunks of skin
The bits you see on the middle cut are chunks of skin
dirty
+1y
Edited: 2/3/2007 12:21:41 PM by dirt mcgirt
this is definately gonna be one of the sickest cars one the scene when ya get it done
good work
where did you get your gas cap from??
this is definately gonna be one of the sickest cars one the scene when ya get it done
good work
where did you get your gas cap from??