K
Frame Table....
///RA TROY
+1y
yep
granth
+1y
so hey man, when they have these rods so low to the ground, thats how they get there? setting the axle above the rails? and just clearance everything for the drivetrain?
TwistedMinis
+1y
Not always Grant. A lot of them just have a huge "Z" in the back. Its not a full notch because the frame generally doesnt drop back down.
xinsertnamex
+1y
be and my bro made ours 4ftx9ft outta 2x2 .187 wall with 2x6 c channel cross braces then but a 5x10 sheet of .375 on top of it and of course it has adjustable feets
///RA TROY
+1y
i only have 300 bucks in mine
impulse
+1y
Edited: 2/4/2007 11:35:10 AM by iLLairgasm
Edited: 2/4/2007 11:34:25 AM by iLLairgasm
Here's the one I built...there's about $300 into it too.
Edited: 2/4/2007 11:34:25 AM by iLLairgasm
Here's the one I built...there's about $300 into it too.
TukinRange
+1y
Do any onf u guys drill holes everywhere >to connect the tubing
impulse
+1y
Originally posted by TukinRange
Do any onf u guys drill holes everywhere >to connect the tubing
that isn't gonna hold much air... not worth the hassle if you ask me.
Do any onf u guys drill holes everywhere >to connect the tubing
that isn't gonna hold much air... not worth the hassle if you ask me.
TwistedMinis
+1y
Corey, where do you keep the table when you're not using it? Thats one thing keeping me from building one..
granth
+1y
same here, I can't have it around all the time, and don't have a "shop" to put it in. I guess a low profile one like that could get por 15'd and go under the back deck though.