engine swaps

i got a 92 mazda b2600i with either a blown head gasket or cracked head... not sure...

i was thinkin of doin an engine swap... to what, i'm not sure...

maybe a 2.0 or 2.2? maybe a v6 or v8?

what do you guys think would be best for this... i wanna drive it A LOT... just can't do that at the current moment cuz of the damn head...

also if you have done any swap, can i get pics?

If you drive it alot and are looking for power, a 4.3L V-6 would be a good choice. Plenty of power for our little trucks. Some one on here was selling an adapter kit for our trucks.check the mazda forums.

yeah i seen that... i'm still debating on whether i run a v6 which i'd have to buy or the 351 that my uncle has...

i'm gonna turn this truck into a daily driver...

ONCE I GET IT RUNNING!!!!!!!!!

4.3 v-6 sounds like a great way to go imo

I believe its No Limit Customs in BC that has the engine mounts for either a SBC or a 4.3

A rotary is a easy swap! tranny bolts right in all you need to is make engine mounts modify oil pan or front crossmember. The stock drive shaft even works with no mods, slid the truck yoke into the RX7 tranny.

I'm in the process of doing a 350 V8 swap in mine it sits under a 2600i hood with all the bracing and a little over 2 inch body drop.I got to get off my ass and finish it i havent worked on in about a month and half.

I got a 2001 4.3 V6 out of my blazer that runs great drove it into the shop b4 i pulled it out to put the new motor in, if your interested i dont know where you live but i got the motor 4l60 e auto tranny and belt driven compressor on it too (motor and tranny have 40k miles on it and belt drive has about 3k miles on it) ill take 1500 obo for it also includes harness and ecu...

kia swap!

see i don't wanna have to worry about the computer and all that shit...

thats why i was lookin at a buick v6... plenty of power along with simplicity...