threads
Page 2 of 5
Air Ride Suspensions \  York 210 Engine Driven Comp info

York 210 Engine Driven Comp info

Air Ride Suspensions Q & A
views 16160
replies 43
following 34
 
jetts   +1y
Originally posted by blackz151



is there any places out there that sell a bracket for the 99 astro wit the vortec v6?

is it the same v6 as an s10? suicidedoors sells a bracket for the v6 s10 which also works in a v6 silverado
Toddgoesfast   +1y
most 18 wheelers used them as well
blazed22s   +1y
Originally posted by sicsan



dumb question proably but will these build up to 200psi and how long would it take to fill 10 gallons of air?????

i have one on my blazer, and i run it to 200psi daily on a 12g tank. i ran it from 0psi to 200 one time and i think it took only 1 minute 45 sec to get to 200psi on the 12g tank. they are fast as fuck. i have one on my isuzu too, but its only 6g's of air with a pressure switch to 145 or 175. not sure. but its never on for more then 30 sec at a time, unless im straight playing with the swtiches
Jacob1777   +1y
I spent a low amount of money. You can cut the a/c lines where they meet the top of the compressor. You now have a small and short pipe inside that  holder. you now take that out and thread the inside of this pipe. now you get a 90 degree fitting that plugs into pipe and than get gavinzed pipe than run copper to a check valve to the tank and your set to go. i also have v-belt so i didnt have to buy a diff clucth. 



02ramon20s   +1y




Can some of you guys post pics of a York Compressor system  mounted on a small block. Im thinking of putting on of my C-10 But im just not to sure on the system. There has to be a way to contain the oil leakage?


pmiller   +1y




What are you guys paying for these compressors?  York 210.  Those of you that have them installed as an engine driven unit, what clutches are you running?  Both for v and serpentine?  And if you had to buy those seperate, how much was your clutch?


Dan k   +1y
I've had one on my truck for quite a few years. Bought it new from Kenworth for $250 with a new clutch. Now I just get them from my dad's work and rebuild them. I have like 5 or 6 now. Most of the used ones I get just need new seal and they work fine
pmiller   +1y
I work on trucks as well.  I can get these at a decent price and I'm wondering what kind of price everyone else is paying.  Other people?



02ramon20s   +1y
Here is my Question????????????????????   Whats better???????   2 Viar 380  vs  york 210

blazed22s   +1y
IMO its a York 210, but it depends on the engine space you have and what kinda air managment system your running. especially the size of your tank and how much your going to be playing with the switches.