biggest rim on a 3.5 bd

not cut alot of firewall you have to cut the shiznit outta them!!

see how the front of the rocker is not layin flat? the person that had this truck before me welded a HUGE plate on the under side of the control arms crossmember, which is holding the front end up right now. I dont know why he did it, my best guess is that he didnt know to pie cut the control arms. (or buy cando ones like i did) the frame has been plated to bring it down about a half inch or so to be level with the crushed/folded up rockers. Im trying to figure out hopefully after i cut off the huge plate on the control arm crossmember if the 245/30/20 tires will clear the fender. The hood supports have already been cut and the hood plated for support, its a very odd truck i picked up.

Good luck with that truck.....its been around the block. It should be close because it should only be a bit taller than the 225

i know its been around the block. this truck is full of surprises.

i honestly dont see how you can lay on the rockers with a 245/30 20 when my 225/30s are left with NO room..unless you have little or no camber but then i think it would start to get close to the edge of the fender

That looks like about 3/8" to me.Thats almost enough room to fit an inner fender in there with your tire.

mabe its just me but the the rims on the king cab look like 18's in the front

Edited: 8/8/2007 1:23:38 PM by dillinja666





thems 20's. Thats how much room i got left to the fender..

does it have drop spindles

no, its got cando arms though ( well the uppers anyways, havnt gotten time to do the lowers yet )