maz2low
+1y
Originally posted by BagdMazda
maz2low what do you mean the original fuel lines will work but ill have to rip out the "tiny line"???
On a Mazda there is 3 lines coming up into the front . I did my swap a long time ago . But the smallest line of them all is a Vent so it is not needed to be hooked to anything
Originally posted by BagdMazda
my truck is an ext cab, so i have 2 driveshafts i plan on getting both strengthened or maybe replaced not to sure which will be cheaper. as far as clearing the hood goes i have the 2600i bubble hood so im not to sure if that will give me enough room.. if not a cowl hood will be on its way. the original guages i want to also reuse.. basically i wont have to touch the fuel gauge.. all i really want to use for sure is the speedo, tach im just going to buy an aftermarket one. as far as wiring goes i dont think there will be to much wiring??? chevy 350s are pretty simple wiring wise.. i think?? what wiring will i have to do to get the motor running??
For the actual motor wiring . really its just 1 wire to distributor , 1 to alternator , 2 to the Starter , 1 to Oil sending unit and 1 to Water Temp unit . I have done away with stock guages but when i did have them i used the original Oil Pressure unit just adapted to block . The wiring is quite simple if you label the wires before ripping engine out .