AZ OB2 comp. Any issues?

I curremtly have been running the first AZ compressor when only "red " was available.........been having it  on the truck for 3 yrs now...........Never had a problem with it EVER!! Looking at getting a OB2 for a future build or add another to my existing setup.

We are still running two of the original AZ Red OB1's on our 97 GMC shop truck. This truck has been dragged all up and down the East Coast from Vermont to Tennessee without one problem on either compressors. Check it out at some shows this summer. I can't wait to get our shipment on Black OB2's this week to check them out. Paul, I am just finishing up my 96 S10 daily dragger on 20s with our new bolt in rear link setup.  Care to put another OB2 to test?

Edited: 5/11/2009 8:26:24 PM by Nissan4x293

AZ_Paul, My OB2 is no longer "burping" and working like a champ  Since that Sébastien had cut the pre-wired relay socket, the red wire and the little black wire right beside it were crimped together during installation. Now, my OB2 relay is already grounded to my truck box, basically having two grounds, with power going to one of them  Tonite, I un crimped the little black wire and taped it beside the red wire for the time being, this resolved the "burping" issue  Sébastien will be here on Thursday, at that time, we'll run the little black wire to the wire which is the ground wire for my OB2 relay, all this as ONE WIRE and this should take care of the thermal overload protection  Let me know what you think, but it should be all good! Thanks allot for all your help and to everyone else as well

---------------------------------------------Originally posted by Nissan4x293Edited: 5/11/2009 8:26:24 PM by Nissan4x293AZ_Paul, My OB2 is no longer "burping" and working like a champ  Since that Sébastien had cut the pre-wired relay socket, the red wire and the little black wire right beside it were crimped together during installation. Now, my OB2 relay is already grounded to my truck box, basically having two grounds, with power going to one of them  Tonite, I un crimped the little black wire and taped it beside the red wire for the time being, this resolved the "burping" issue  Sébastien will be here on Thursday, at that time, we'll run the little black wire to the wire which is the ground wire for my OB2 relay, all this as ONE WIRE and this should take care of the thermal overload protection  Let me know what you think, but it should be all good! Thanks allot for all your help and to everyone else as well ---------------------------------------------  Glad to hear this bro, send me photos of your wiring I'll double check again to make sure you're safe, thanks buddy.  -Paul, Air-Zenith, www.air-zenith.com

Paul from air Zenith there is a recall on the old ob1 air zenith, mine definitly is older than 2006, the thing has given me nothing but problems. Will you take it as recall?

Edited: 6/13/2009 11:05:56 AM by AZ_Paul

who is this?  This is Paul from AZ, I will take care you call me on Monday at office (702) 270-7988.