Just a few updates from last week. Tax time has swamped us with work, so were not posting as much, trying to keep up.
Little bit of weld port to start the post off...
[img]
http://sphotos-a.xx.fbcdn.net/hphotos-ash3/883583_560631753961378_653939261_o.jpg[/img]
F150 Kits are flying out the door!!! Sold 8 in a 2 week span... seemed weird lol. Best part about it, after we sold the first 4, we called all the guys back, and refunded some money to them, because they qualified for a group buy discount!
[img]
http://sphotos-b.xx.fbcdn.net/hphotos-prn1/62448_560649207292966_26832231_n.jpg[/img]
[img]
http://sphotos-a.xx.fbcdn.net/hphotos-ash4/483784_560654353959118_167751683_n.jpg[/img]
Were so busy, even I have a MIG torch in my hands... that hasnt happened in a while..
[img]
http://sphotos-a.xx.fbcdn.net/hphotos-prn1/69891_560677690623451_1810267734_n.jpg[/img]
We get this all the time from customers, and its hard to explain without being a dick. So, i will let the picture do the talking.
Why do our products typically cost more than other companies? Because we refuse to skimp on our materials when the price of steel goes up. All of our bushing ends are ALWAYS 2"ODx.250Wall DOM steel. Compare it to the competition which uses half the material. Remember your entire vehicle pivots off of these bushing ends, why skimp on something so important? But dont worry, when your bushing ends break out, we can rebuild them for you, the price doubles however....
[img]
http://sphotos-b.xx.fbcdn.net/hphotos-snc7/485060_560784700612750_1410085116_n.jpg[/img]
Remember to follow us on instagram @MichiganMetalWorks you will get to see random shit from around the shop each day:
[img]
http://sphotos-b.xx.fbcdn.net/hphotos-snc7/215433_561104060580814_1432862248_n.jpg[/img]
[img]
http://sphotos-a.xx.fbcdn.net/hphotos-snc7/313470_561092050582015_341095358_n.jpg[/img]