threads
Page 2 of 2
Body work and Paint \  mixing board

mixing board

Body work and Paint Q & A
views 816
replies 13
following 13
 
Nsane   +1y

I'm with lost cause on this one> X2 for the clean sheets! Another tip is when the edge of your spreader starts to seperate, rub it back and forth on a flat piece of cardboard to flatten the edge.
redspowerjams   +1y
Edited: 3/27/2010 12:09:28 PM by redspowerjams

I use a 1/4 thick pice of glass. I like it because after im done i take a razor blade and scrap it clean and it's ready for next time and it don't flex.. works grate.. I have had the same pice for 7 or 8 years. 
specv02   +1y
Ive used a 10x10 piece of sheet metal for pry 10 yrs works awesome use laquer thinner to clean up then u can mix more right away.
slammedcivicsi   +1y
i just have a piece of sheet metal, I clean it with gunwash and a rag. Been using the same board for over 10 years.