Unusual Fabrication LLC

Hey guys just wanted to let you know that I will be updating the pricing on my website so the current prices will be good until 12/31/2011 and the new pricing will be up on 1/1/2012. For example, the Triangulated Lower Control Arm Kit I make and sell is currently $92 shipped and it will be about $100 shipped after the new year. I have been holding off for awhile now but with the price increase of pretty much everything it takes to build, package, and ship parts, I have to adjust accordingly. Thanks again to those who have purchased from me and for all the support I have gotten off of this site!

very nice stuff nice ideas on your table

Thanks David!

I seem to be slacking on this thread lately but i've got a full chassis build going on and I just landed another backhalf so i'll hopefully be updating this alot more. My bender will be getting a workout!

Edited: 1/8/2012 1:31:22 AM by UnusualFabrication

Just some leftover parts we won't be using on the Vega project...

Edited: 1/9/2012 11:43:21 AM by UnusualFabrication

Sometimes when the laser is broke and you need a part and you do it by hand...

Machining some balljoint cups for S-10's:

Started with this...

Cut them into pieces on the bandsaw and started turning them on the lathe...

Finished cup...

Finished the spindle jigs for the front suspension and pretty soon i'll be building the actual frame...

Test fitting the wheels and tires and as I suspected I am going to have to stretch the wheel wells. This is fine because i'm going to increase the wheelbase at the same time. I'm going to have to clear more around the tire because it needs to go up about 1" more.

A few more updates on the Vega:

Marking out the rear quarter panels for the wheel well stretch...

After removing the inner fender well I finally got the section off...

Test fitting the stretch. I'll have to make a new piece for the opening and i'll have to match the bodyline on the bottom right side...