Project cleanup

Did you retain the PTC heater plate when you installed your Weber? If so, I'd plug in the wires.

If your PTC plate is now in the landfill with OJ Simpson's clothes and knife from the night of the murders, then just cut off the wires.

Do these wires run off the ecu? Because I have removed that I still have the ptc heater bug I'm trying to get rid of all the wiring for the emission

Sent from GS2 on Tapatalk

Project cleanup phase one!
From this


To this!



Can you say good riddance?


Sent from GS2 on Tapatalk

NEXT UP WIRE TUCK!!!

Sent from GS2 on Tapatalk

Looking good. The wire tuck is fun. Time consuming but that's because I'm a semi perfectionist when it comes to wires lol.

What did u do with the fuse block bracket? I too plan in moving mine next to or under the battery

Sent from GS2 on Tapatalk

I ground off the tack welds and removed the bracket.

I used the two rubber screw mounts that were on the fender holding one of the brackets and screwed the into the right two holes which fit the fuse block almost perfectly.

Did u have to extend the wiring any? Also what about the harness that goes under the intake to the rear of the motor? Can any of it be rid of?

Sent from GS2 on Tapatalk

The only wires I extended were the brake level sensor and wiper fluid sensors. Everything else is stock length.

Okay next question... I see that many people have cut a hole in the inner fenders thing (don't know what it's called dammit!) I don't have the ability to do as such for now could I run the wires through the lil holes here?
I know it won't look as clean but it still gets them out of the engine bay and it requires no cutting... Just wondering thanks in advance

Fred

Sent from GS2 on Tapatalk