threads
Page 2 of 8
Mazda Engine General \  motor un-install

motor un-install

Mazda Engine General Mazda Engine Mazda Tech
views 10643
replies 71
following 7
 
delawaredime   +1y
well, i found a big square headed bolt on the driver side of the trans that you can drain the fluid with...
schreff   +1y
There ya go. should make it a little lighter.
delawaredime   +1y
lol, i hope so.
schreff   +1y
Remember dont forget to take the shifter out. LMAO.
delawaredime   +1y
lol, i hear ya. i started takin off what i could tonight, drained the oil,antifreeze, and took out the radiator. hopefully tomorrow will go smoothly...
schreff   +1y
It should bro. If you need anything give me a call.
delawaredime   +1y
the 2000 motor should work with my 2200 right?
schreff   +1y
Yea pretty the samething. The insides are the only differance.
eksessivdragger   +1y
when i swapped motors, i just unbolted the tranny from the motor b4 pulling it out. only thing i drained was the antifreeze. I swapped in a 2.0 in my B2200.
delawaredime   +1y
well, from what me and mike seen, the motor mounts are different. i pulled my old motor, and then sold it to dropdmazda, lol before we got the other one in, now i need motor mounts.