threads
Page 2 of 2
Mazda Engine General \  fuel cell questions

fuel cell questions

Mazda Engine General Mazda Engine Mazda Tech
views 1796
replies 14
following 7
 
dpeckx   +1y
my webber instal instructrions 32/36 that is says no more than 3psi. 1.5-2.0 is recommended. the stock manual pump on a b2200 will put out 3-4.5psi. I've guage it as well and that is what it runs at. A cheap reg can bring it down but you don't need to worry about leaks at that pressure. The only place you are going to feel anything is when you hit it hard she'll bog a little.
blare   +1y
umm anyone got a how to on hooking up a fuel cell. What lines i would need fittings etc....
drpdmazda   +1y



i think mine just has two lines on it, one to send gas and one for a vent, that goes to the front of the truck, i will check and get back to you
blare   +1y
thanks man
nytrdr24   +1y


here is a link from aeromotive;

it has some basic setups, with line sizes, depending on what cell,
pump, filters, & regulator (if needed) you have, you will need different
fittings, and line, these are just some depictions.

they make all kinda stuff for your fuel system. i'm going to run a jaz prostreet fuel cell with universal sending unit, an aeromotive fuel pump, two of their fuel filters (one inbetween cell and pump, one between pump and reg.) and their universal by-pass regulator.

hope this helps!