New Ford Ranger

Or just get a 9".

Yes that is the real option, but not many people want to buck up for it.

They're not as expensive as one might think if you build it yourself. If you find one with the right gear ratio you want in a junkyard, you can shorten the axle yourself, or have it done for around $300. And new Moser axles are $300 shipped for a pair, any bolt pattern you want.

But its still a headache.

The only problem with that is you get side to side movement with a parellal four link with pan hard bar this is when ever you are going up and down with the air and it only truly center if you built it at ride hieght.

WATTS LINK, or TRAC BAR that triangulates the lower front right mount and the lower rear left mount....

those 8.8s like bracing to hold them together. and it looks pretty sweet, a couple heims and some dom and bam pimpin rearend

Yeah, now I know that...If I keep my truck it will get enderbraced, and get shortened with new tubes anyways. should keep me from blowing it up again( until I find a way to fit foot wide 24's on the back)

foot wide 24's huh? going the superdonk or donkrod route next?

DONK are you joking...Layed out and tukin 12 inches of rim.

24's will fit under your bedrail? or will you have the funky wheel tub over the bedrail?