Engine Cuts Off When Stopping

I was wondering if anyone else has had this issue with their B2000. This only happens on certain days for some reason. When I take it out of gear and start to brake the RPM's just drop and will stall the motor out if I dont hit the gas pedal before it cuts off completely. If I pull it out of gear and ease to a stop very slowly I can get it not to stall, but a normal or hard stop is almost certain to stall. The next day it will drive fine, shits got me stumped.

Throw in your 2 cents here -->

i have three mazda's and they all do tha same thing. i waz told it waz the distributer.
something with some internal bushings wearing out.

i have yet to figure it out for sure tho.

Peace N|ck

I had a similar issue, changed cap rotor plugs and wires even coil and nada. The carb was outa wack, if you have a dwell meter you can check it, you could be running super lean, I was.

i have same problem also changed my cap/rotor/plugs/wires/timings good/tried with a holley & a weber carb and the dawg just loves to sleep...got it stored up but after i finish with the interior i got to get back on the troubleshooting because this one is really making me scratch my head... one min its rich the next its lean

mine use to do it and then i swapped over to a weber and got rid of all the emissions shit and computer and it dont do it anymore




-justin

Interesting....

im running a weber and it still does the same thing.....

Peace N|ck

Check ignitor and pick-up, inside the distributor.

you think if i just replace the distributor it would help out quite a bit? just i know they arent that cheap

Check to see if the EGR valve isn't clogged up with carbon. Mine did that for a couple of days till I took it off and cleaned it out.