Lowering Guru's needed!

Mazda Lowering Static Mazda Suspension Mazda Tech

replies 44

following 12

slambert +1y

Yeh a couple like that would be great, cheers!

dangersoulylow +1y

no problem.... for the front all i did was crank down on the torsion bars bolts

sierrax +1y

Dangersoulylow, that is a mono leaf setup. The main leaf with the overload (the overload is the short thick one). Like stated before it is not a safe setup. In Ontario the MTO will yank your plates for having that if they catch you ,not to mention that it puts way too much stress on the main leaf as the overload is the only thing holding the truck up and keeping the main leaf from bending the opposite way. Just look at a Belltech monoleaf which is as thick as about 3 regular leafs so it is strong enough.

schreff +1y

if you put the helper leaf on top of the main leaf it will give it more strength. It will only raise it about 3/4 of an inch... I ran this setup with 3in blocks for years... Never had a problem.

Sent from my SCH-I605 using Tapatalk 2

dangersoulylow +1y

for to take pics i will try tonight.... i was bear hunting insted bright side i killed a bear...