stock gas tank on baggged truck

Well.. u can run a bigger notch.. you just have to lower the upper brackets to make sure ur getting full use of the bag. I hate to say it but those notches aren't fun to work with... i would use an 8 piece if possible.
Mike

Oops, I forgot about people running an over the axle setup.

Ok sweet. Then I will start workin on it very soon. As far as mountin the gas tank in back between the frame rails. 1... Will I have to make a mounting bracket or will it bolt up. 2.... If I'm draggin and sparks are flyin wouldent it be bad that there going right next to the gas tank?. 3.... Will I have to cut out a section of the bed right above the fuek tank or will it fit under the bed with no modifacations?
Thanks again

yes they're a pain to work with when you have a boxed frame, but frames like rangers that are C channels are easier

your stock tank will fit between the frame rails you might have to notch a little out of the fram on both sides to make it fit or come up with some bracket assembly so you dont have to notch the frame that blue truck posted on this section is mine i just finished doing the same thing you about to do when i installed my four link i had to move the tank to the back just take you time and think one step ahead of your self before cutting things out and evryth8ing should be good and whowas the person who posted my truck in this sectionit most of been some one from flateline cool good luck and hope every thing goes good .