Just got my first mazda.Sold :(

well im learning as i go haha, its not hard least nothing i have done so far has been difficult mainly time consuming, only thing is if you mess up or do a bad job you have a lot of snading ahead of you lol i learned that my first time using bondo, i had a 94 civic hatch and shaved the license plate hole and put some filler over the plate to seal it all and it was my first time lol i had a good lau8gh about it afterward haha

i wonder how his motor is still sitting as low as it is, also if i did bd it i would have to door it the lil peice of rocker right there on this truck isnt where it should be on mine lol the gap is horrendous on mine

dropped motor mounts.

so hows it coming along?

its coming along alright lol i just got the first coat of glass on the bed tonight and decided to let it dry overnight and get on it tomorrow after work i think it will turn out alright, least for the box still concerned about my cab though.

dropped mounts can only get it so low lol thats like a 4- 4 1/2 in body drop thats a lot lol

dropped mounts on a custom frame perhaps?

i dunno you figure two and a half you can do with no hole, so if it is a four and a half the engine would come out a few inches maybe four, then the motor mounts would drop it back down an inch or two. cause its still out a good inch and a half to two. just guessing here, ha.

lol
hahaha
yea man, we shall see whats gonna happen first im finihing the bed!! lol

Motor is in the stock location. Just has a low ass carb.

oh, lol you know the owner?

craziness. would you happen to know what kind of carb?