Just got my first mazda.Sold :(
slammedyota91
+1y
Well, GAY, So I mounted my tank, valves, compressors, and what not, driver side is completely ground down and ready for the brackets, While finishing the notch we ran out of wire Im pretty disappointed. So right now, Im running my switchbox wires to the vlaves and the relays for the compressors. Tomorrow morning I am going to go get some wire, And hope we dont run out of gas for the welder, anyway things are going pretty good, the driver side notch is complete...
slammedyota91
+1y
Me Wiring up my valves, Well, Running the wires, Gotta get some butt connectors...
How it will look, Tank mounted and everything.
Driver side all ground down smooth
Driver side notch done..
Pretty much the only way to mount everything with the small amount of metal I have lol, Works, and soon another 5 gallon tank.
Passenger side as it sits now.
How it will look, Tank mounted and everything.
Driver side all ground down smooth
Driver side notch done..
Pretty much the only way to mount everything with the small amount of metal I have lol, Works, and soon another 5 gallon tank.
Passenger side as it sits now.
slammedyota91
+1y
Me Wiring up my valves, Well, Running the wires, Gotta get some butt connectors...
How it will look, Tank mounted and everything.
Driver side all ground down smooth
Driver side notch done..
Pretty much the only way to mount everything with the small amount of metal I have lol, Works, and soon another 5 gallon tank.
Passenger side as it sits now.
How it will look, Tank mounted and everything.
Driver side all ground down smooth
Driver side notch done..
Pretty much the only way to mount everything with the small amount of metal I have lol, Works, and soon another 5 gallon tank.
Passenger side as it sits now.
slammedyota91
+1y
dbl post.
elbine69
+1y
Lookin good yo. Planning on finishing it up today if you get some more wire?
jmzcustomz (jeff)
+1y
Nice progress. Did you find it harder to get your grinder in there with the UC and LC still attached? I am thinking about stripping it completely down any suggestions?
slammedyota91
+1y
Yea going to go get wire right now, and start back on it. pretty stoked
slammedyota91
+1y
Eh I guess its entirely preference, Its not any more difficult to me, I never use the handle on the grinder and w/o the handle I think its easy, If you like the handle then yea I suggest removing the upper arm the lower isnt in the way at all. All I did was tie the upper to the fenderwell so it was out of my way, I dont like removing things if I dont need to..
twisted minis
+1y
That notch isn't done, you need to weld the bottom.
southernrazed
+1y
eh man if you still have those fittings let me know what ya got.. and what you want for them..