threads
Page 39 of 49
Mazda Projects \  Sparky Mazda (Finished Pg. 31)

Sparky Mazda (Finished Pg. 31)

Mazda Projects
views 73843
replies 482
following 51
 
usmcperez   +1y
Not sure if this helps but the axle is out of a 84 mazda sundowner
twisted minis   +1y


All that info is already posted. The wheel wells are wide enough to clear.
sik and twisted   +1y
Why did you guys Decide to switch the rear end out?
twisted minis   +1y


Because the stock axle is too wide. The tires rubbed the bedsides, just laying frame. And with a bodydrop, the bed would rub harder and probably hold the back up or buckle the bedsides. The bed gets narrower at the top.
slammedyota91   +1y



excuses excuses just kiddin bro, lookin awesome, so i was actualy gonna bd my tuck secretly this winter but with all this body work needing to be done i doubt it will happen oh well. maybe next truck!!! you sure you dont need me to measure anything for you? for that upper bar
twisted minis   +1y
Well it needs to be about the same length as your lowers. So about that. You're going to have to make a crossmember to hold onto it.
slammedyota91   +1y
crossmember is in the works, link bars are about 24" ill meausure em to be sure
twisted minis   +1y
Yea measure them for sure. And make sure you can mount those under the frame without them hitting the ground. I think they will need to be around 20" to mount them by where the leaf spring mounts. The stock leaf spring mounts hit the ground.
bagdb2200   +1y

For lower link bars Seth? My truck has 25-26" lowers under the frame and the front mounts clear the ground when layed out.
slammedyota91   +1y


its real close, real close lol ill measure