Sparky Mazda (Finished Pg. 31)

You're going to water me? I don't need to grow anymore. Its already tight enough in my truck as it is. Lol.

And I don't fit in this truck. So far nobody I know does. I think its the seats, because I had a ton of room when it had a bench. But now I literally can't fit. My little brother is 5'2" and is pretty cramped.

i didnt know yo swapped out your bench...

I'm talking about the Mazda. It has buckets now and they are taller than the stock bench seat was. The thing I don't get, is this truck is about 5 inches taller than mine, and I've got 2 inches more headroom in my truck. And my steering wheel doesn't dig into my legs. I'll take a picture tomorrow, the steering wheel is like 7 inches from the seat.

Danm dude I got to get pic of the motor mounts I use and build they kinda look the same except mine have the chevy mount end instead of the mazda mounting hole

Heres that alarm system.


Previously to mount it, it was shoved up under the dash and wedged in between the speaker and fuse panel. So now I'm trying to find a good spot to mount it where it can be worked on if need be, but out of plain view. Anyone have any ideas?

Will it fit behind the kickpanel on the drivers side?

Nope. I don't know about your truck, but the kick panel on the driver side is not like the one on the passenger side. There is about 1/8" between it and the part of the cab it mounts to. The wiring doesn't fit behind it.

typically on the left side where the speaker goes theres a hig area there, and you can hide it up there, or what i had to do on somce vehicles is pull the gauge cluster and to the left of that theres a gap of nothing... good luck

I got it attached to the bottom side of the cowl. Got the carpet in, and cut. But it really needs an untrimmed kit. Its too short. Another 1.5" on each side would have been perfect.

Will get better pictures tomorrow.