PROJECT: Redemption (93 b2600i bagged and bodied)

Thanks man. .

Ya i'm keepin the stock arms. . . And yes. . thats all I did to the arms. . . I still have to weld the tabs on for the triangulated arms. . But they are done for the most part. . And I angled the lower ball joint up a little. . And the uppers are reverse pie cut. .

-Josh

Looks good man!! I really like the rockers. Im thinkin about building some new rockers for my truck. Body drop looks like it came out real nice. Keep up the good work!

thats gonna be just enough lift it looks like. because after you get another inch or two of tire on there for the 20s shes gonna be really close. thats bitchin. im curious to see a front frame shot with the bag layed out and aired up now that you have it all together.





-justin

good job on BD and this gets quite a bit of lift.. sweet!

do you plan on running bigger breaks?

Yes. . I jus don't know where from. . . Do you know where to get big brakes for toyota spindles? ? I looked at phattys.ca. . . but the website is shut down. . thats the only place i have heard of. .


-Josh

Get in touch with LaynRockers(John) he may know where to get some. I know he has done it before. An I think he knows where to get rear disc converstion for the toyota rear also.

does wilwood not offer bigger breaks for yota spindles... i believe they do i seen a build over at yotascene that had wilwood big breaks

I'm not usin the Toyota axle. . I am using a Nissan 300zx Independent rear suspension. .

And I'll check it out, thanks Andrew!

-Josh

And I need a break from the bodydrop. . To get my mind off of it but still play with my truck. . So here is a lil preview of what I am doin. . .


-Josh