badchicn (rick)
+1y
Oh yeah and I re-mounted the rear licence plate. I had to cut 1/2" off the top and redrill the mount 1/2" up. It raised the plate almost flush with the bottom of the roll pan. The new Cali licence plates are aluminum, cut like butter with my tip snips. The old ones were some type of steel and you needed a cut off wheel to trim them.
The only down side to the work I did this week end is I found out that the lowest point on my truck is the air tank, followed closely by the gas tank. Both are scarred up pretty good and I haven't really dragged it because I knew about the gas tank. I am looking at a moon eyes 15 gal spun aluminum tank (mounted at the front of my bed)and an external fuel pump (mounted on the frame rail). Then I think the air tank can be raised by mounting it from the other side of the frame and spacing it up agaist the bed floor. It looks as if I can raise it 3" and get it above scrub. All this will be done after the wood bed floor, so I have to be CAREFUL.