My 86 mazda

Looks good! I like the gold. Are you going to paint it the same color again? Those 17's look huge in the pics LOL!

looking good...

that looks really good and one question did u use 2x3 box tubing for the frame affter the notch

nice nice nice

why so big of a bd? man you do good work looks awesome man i like it so clean...

that looks bad ass. you know, if i ever learn to weld, my truck will never git finished.

the body drop looks clean. the only thing id advise would be to cut the tranny tunnel and drop it down as much as possible. i know it will go atleast 2-2 1/2 inches. that will make it easier on you to mount the heater core back up.

The reason for the big bd is, the rocker on the passenger side had a huge dent in it where the truck bottomed out. If i bodydropped it the rockers, about 2 foot of the rocker wouldnt lay out, so i cut them off and made new ones. Yeah i used 2x3 for the rear clip, after the notch. I was going to keep the heater core, but i decided not to use it. It also looks like i might have to switch to a four wheel drive fender, because the wheel barely clears the fender. So if anyone has a set i would be interested in them.

good luck on the fenders. they are hard to find and nobody makes an aftermarket replacement. try . you can put in what kind of truck you have and what you are looking for, it will give you a list of salvage yards sround your area and their info. look for a 93 mazda b2600i 4x4. that will give you the most info

Mazdawg, thanks for the link. I went to a local junkyard today and found a good driverside 4x4 fender. Had only one little ding in it, i paid $25 for it. now to find the passenger side.