Project: Sheeba

well here is some more pics for you pic whores




little more cutting for extra room.


thats frame baby.



-justin

Hey, how do you figure out if your going to lay frame or not when doing it?

...lol, I'll have to take my time on the back of my truck before I do the front so I can get my plasma cutter!

looking good bro keep it up

Measure from the ground to the frame, and then from the ground tot he tire and make sure it matches. I do it without the wheel even. Use the radius of the tire and measure to the center of the spindle, and calculate to compensate for how much taller the wheel gets with camber.

or run a joint of 2x2 or something along the frame rail to the tire and see if it is the same level.

Simple enough!

lookin good so far.

Good jpb Justin, Lookin good man, Cant wait til the front is laying down, Im excited and anxious for my texted video

looks good man

yeh ive just been using a 4 foot level and running it long ways down the frame to the bottom of the tire. welp just checkin this before i get to work on it again.







-justin