mazdafvr
+1y
hey guys, I did the 2.0 head swap and put in a set of rings while I was at it and over the last few days after work I been tweakin on it and trying to get the valves set, carb tuned ect. I think I got the valves close, I set to .008 mm and theres still some clatter. but somthin still aint quite right, like sometimes when I rev it, its firing but the motor hesitates just a little, maybe a little sputter here and there at idle. I tweaked all through the carb and that aint it, I found a few vacuum leaks, fixed them, made a bit of a difference. but thers still a miss somers. I was hauling ass thru my field last night and I had my foot down not all the way but a good bit and it stopped accelerating for a few seconds, it was still maintaining speed but just no power then bam! took off again. almost like a plug wasn't firing or a cylinder wasn't getting fuel but it was real quik, like a second. but when its not doing it it seems to run a hell of a lot better than it did. so im getting close. any ideas, I used almost a hole can of starter fluid looking for leaks, the hose that runs from brake master to intake was leaking like hell but I replaced it. thanx in advance