B2000 drift truck build

"Some modification Required"





motor mounted, Disregard the temp aluminum spacers.





Spent most of the day Chainsawing and driving a bobcat, then some more time getting this thing back on the road after my last "incident". Now I get to go work an 8 hour shift dead tired.

curious, isn't that header a little too close to the mount? like for when the engine is vibrating, wouldn't you want a little bit more clearance between the two?

^^ he has a point but then again you dont want to take to much out of that mount either.

Ya its still a little too close. The header and mount will move together, but I still need to open the gap some.

trans mount finished.

how does this happen?





and the next project on the chopping block, in the design phase

You should see some of the rust spots on the Mazda I just picked up. Body has holes, and over the winters of water getting between the cab and bed it almost cut the frame all the way through.

Me likey the new project

dude nice work so far man. and is your next build a jeep??

Nope, its Japanese.

???what is it then???

looks like a Suzuki or a mitsu