B2000 drift truck build

nice bit of progress man.

awesome adjustable bump!

Looking very good. I got my driveshaft done at Chattanooga Driveline. I'm also very close to finishing my swap too. I'll see about letting you test drive it when done.

I found another ka24e for 100$ with wiring harness and ecu so it looks like ill be picking that up as a spare motor - motor to build up for boost.

Mind if I ask how much you paid for them to do it? I have already been by there and they said that was a nissan only yoke and I would have to get it from nissan.

What swap have you got going on and where in chattanooga are you? Im in the hixson - soddy daisy area.

actually if its from a ka motor you might be able to just snag a hard body input shaft and driveline. man how cool would it be if it just bolted up


btw im not sure if all the b2200 truck had them but my beater truck, either someone put a locker in it or is has limited slip. cuz she lights up both tires. maybe some thing to look for in the future

Ya the local shaft I found is a 2 piece out of a hardbody, but they want way too much for it.

My Diff is as open as it gets, but I plan on welding it. If I blow up the diff or snap axles I may swap in a narrow 8.8 with discs.

when you weld these axles up the weakest link becomes the spider gears. Here's a page you might find useful:

" target="_blank

and this one:

I'm the guy that PM you about welding. I'm doing a Starion motor swap on a B2200. I paid $140 to have the Starion driveshaft welded to the rest of the B2200 shaft. I'm in between East Ridge and East Brainerd.

Got a new daily driver since a 4x4 on the street is not too practical.