Her Name is Frank

Looking awesome man, I can't believe I missed the pics of the Link Setup! Let me know when those switches get there.. Can't wait to see more progress on FRANK

hey main wtf with the milk carton in the engine bay i know im the only one to ask but i gotta know

Lol, no prob Ricky. I'll let you know when they get here. Those will work for doing front bags, rear bags, and pancake right?

oldskewl, that was there to catch the brake fluid. I pulled everything off the front of the truck, and I disconnected the brake lines, and didn't want it all over the floor.

Also, here's a picture of my shifter. Had to put it on the lathe again and msooth it out after dropping it.

I'm going to have to move the master cylinder, a lot. Anyone done this before?

Got some parts today. Got an extra set of uppers to cut up to build my new uppers, to fix my camber issue. Also got a steering wheel in the mail. And, whil elooking for uppers, I found the fender I needed and it's pretty straight. Just has like 1/8" of paint on it. Lol.

damn man you do reall good work how much for one of the bolt in x-members?

Thanks man.

The X-members aren't 100% bolt on. They come with weld on tabs, and then are removeable from there. I'm going to sell them for $120 with hardware, plus shipping.

damn dude bad ass work I really like how you did your lower control arms, what kind of tubing bender do you use?

Thanks Baha. Normally I use a Pro Tools bender. But I used 1" DOM 3/16" wall, and it was too thick to do wiht the manual bender. So, I used a hydraulic pipe bender and it didn't kink. I'm going ot use the same stuff for my upper arms.

u know ur shit.. thats for sure.. keep the pix comming along... rock at this shit..