Sparky (Warning, not Toyota)

I figured it was a clean way to work in the rear bed mounts. I'm going to drill a hole in the top so I can bolt the bed down right there, and its cut at an angle so its easy to get to. I thought it looked cool. I'm going to do the other mounts like that too.

cause i know these are hard as fuck to come by so i was gonan get them i think i still might go get em and same em for when a fellow mini truck need em ill have a set

Thats true they are very difficult to come by. I spent roughly 4-5 months looking for the one I needed.

any other parts u lookin for this truck had some desent doors 2 i think

I need the seals off the doors with one piece glass. The piece that goes on the bottom of the glass and slides along the glass as the window goes up and down to keep water from fallign in the door. You know what I'm talking about? I don't know if they have a name, and Toyota says they can't get them.

Tonights progress, backhalf welded, bed mounts need holes drilled, and bag mount are about 1/2 way done.

Looks good man nice joints

damn dude.. shit is lookin good.. i want some bent tubes on my bed.. lol

Got the bag mounts pretty much finished up. Going to mount the gas tank after lunch.

that is a clean ass set up . I'll be up in nor cal in june . i gotta see your work in person man. deff comin along and fast too

I doubt there will be anythign to see in June. This truck is due backl the first week of June and my truck isn't due back then.