Nissan 720 Project (Finished)

They are not billet. They are cast aluminum. Check McMaster Carr. They were about $15.

Nice work.

Triangulated lower control arms, and cut 1.25" off the top of the arm and plated with 3/16" plate to lower the bag down.




Unfortunately, the suspension is still about 1.5" away from laying on the new tires. The upper bag mount is just not set up right, which I did not do BTW. I will probably be redoing the front bag mounts after Reso. They are a little haggard.

Very nice...good work.

seth when you tri the lower arms do you take them off to do this ...cause i want to do this to mine but not sure on how to do so

Yeah I take them off to do it. I use a jig to keep the pivots in line with eachother.

/\ same as how i did mine, followed your build ha.

so when the 720 was first bagged did it come anywhere near low?

Yeah, it just had little wheels on it.

What size tubing do you use for the arms?