Wakeboard03S10
+1y
these are the specs on the amp that I have. Features:
* High-Efficiency Switching Power Supply * "Direct Connect" Terminal Block Allows for 4 or 8 Gauge Power Wire * 2 or 4 Channel Inputs Allow for Non-Fading Bass * Full-Size Die-Cast Aluminum Chassis * Variable Low-Pass Crossover * Variable Bass Boost * 2-Ohm Optimized, 1-Ohm Stable
Subwoofer Mono Amp Specifications
* Amplifier Type: Mono * RMS Power @ 4 Ohms: 600W x 1 @ 4 ohms * THD at 4-Ohm RMS Power: 0.1% * Bridged RMS Power @ 4 Ohms: 1200W x 1 @ 2 ohms * Speaker Level Inputs: yes * Preamp Outputs : yes * Built-In Crossovers: LP * Bass Boost: 0-6 dB * Frequency Response: 10-320 Hz * Signal to Noise Ratio: >100 dB * Dimensions: 14-13/16 L x 10-13/16 W x 2-11/16 H
here are the sub specs.
* High-Efficiency Switching Power Supply * "Direct Connect" Terminal Block Allows for 4 or 8 Gauge Power Wire * 2 or 4 Channel Inputs Allow for Non-Fading Bass * Full-Size Die-Cast Aluminum Chassis * Variable Low-Pass Crossover * Variable Bass Boost * 2-Ohm Optimized, 1-Ohm Stable
Subwoofer Mono Amp Specifications
* Amplifier Type: Mono * RMS Power @ 4 Ohms: 600W x 1 @ 4 ohms * THD at 4-Ohm RMS Power: 0.1% * Bridged RMS Power @ 4 Ohms: 1200W x 1 @ 2 ohms * Speaker Level Inputs: yes * Preamp Outputs : yes * Built-In Crossovers: LP * Bass Boost: 0-6 dB * Frequency Response: 10-320 Hz * Signal to Noise Ratio: >100 dB * Dimensions: 14-13/16 L x 10-13/16 W x 2-11/16 H
here are the sub specs.
Low_SST
+1y
hey andy you need to wire them like the second pic i posted in teh first page. the only difference is that instead of bringing the 2+'s together at the amp put them on their own "channel" on the amp and do the same for the -'s
