'97 Integra... SMC Cans, Front Not low enough... back is fine.

Just installed SMC Cylinders on all 4 corners...

The rear brackets are set at the center position and when layed out, it sits perfect (about 1" off the ground).

The Front however sits almost as high as stock! I even removed a 3/4" bolt that goes on the Cylinders Rod to lower it just a bit more, but you can't even tell the diffrence.

Any idea on what I can do to make the Front drop lower? I don't think any thing is "hitting", I think the Cylinders are compressed to the max and thats it.

Thanks all!J

did u get the 4x4 ones?

Yes, the front are 4x4, the back are 3 1/4 x4 SMC from Master Image Customs

A BUDDY OF MINE HAS A CIVIC AND HIS UPPER CONTROL ARMS, WERE HITTING THE INNER FENDERWELLS. HE CUT THEM OUT AND IT MADE A CONSIDERABLE DIFFERENCE.CHECK OUT SOME HONDA PROFILES AND YOU'LL SEE SOME. THAT AND HE ALSO MOUNTED THE TOP OF THE CYLINDER W/O THE BRACKET STRAIGHT TO THE OPENING IN THE FENDER.HOPE THAT HELPS A LITTLE.

There did you get those from

the front usally dont tuck with the 4x4 they get low but not too low do u have a pic?

cut it up

Edited: 11/30/2006 12:39:36 PM by integraoligist

Edited: 11/30/2006 12:39:01 PM by integraoligist

Yes, I know it's a bit hard to see, so i added the red lines to show the gap from the top of the wheel well to the top of the rim to give you a better idea.

Thanks all for the help!J

Edited: 11/30/2006 12:44:34 PM by 1 LoWfUKn RaM

thats as low as ur gonna get with out cutting out ..

you didnt do something right i put them on my buddys acura and it is almost tuckin rim check my profile out to see it