I HATE COMPRESSION FITTINGS!!!!!
867 views
30 replies
23 following
I HATE COMPRESSION FITTINGS!!!!!
chris03hd
+1y
I use nothing but stainless compression fittings.
Seems the big advantage over brass, is that male end is the fitting side, and the female end is in the cap. You can tighten the heck out of them, and they stay super tight and will not overtighten and strip like brass, where the female end is the fitting side.
Wish I could post a side by side pic of these brass, .vs. Stainless.
Seems the big advantage over brass, is that male end is the fitting side, and the female end is in the cap. You can tighten the heck out of them, and they stay super tight and will not overtighten and strip like brass, where the female end is the fitting side.
Wish I could post a side by side pic of these brass, .vs. Stainless.