square body ranger bodied on 22s

Come on Josh. Hardline is easy. What you have built is the pain in the ass part.

DAMMMMMM THAT IS A NICE SETUP FRONT AND REAR...GOOD JOB MAN

bad ass fuckin truck man i got a ? for ya  i seen the awd suv tech article that u are doing to lay out with the awd shit on the lower controle arms are those uniballs  u are using? and im interested in the ball joint stud what is that and were can i get some? check my ranger out its stock floored 3 in and cut floor 3in to the doors with 2 1/2 in section out of the rockers i was running mustang 2 up front but the ball joints are locking out and i cant get enough lift for the 20s so imma run uniballs and build my own .

any updates on this thing!?

Dude this thing is stupid sick, you do some awesome fab work and congrats on the construction zone feature with the taco. I was thinkin about using the same type of set up on my control arms on my 73 courier. I'm goin' to run paralells in the front this will keep 0 camber through travel but the only issue I have found is as the susp. lowers the track width gets narrower, I've made a pattern to exact my control arms and I found that with ten inch long arms at five inches of travel the track width narrowes 1/2 inch and at eight inches the track narrows 2inches. I don't think this will be a prob with a dailey driver because Im running Bilstien aluminum bodies in the front so I doubt the susp.will travel anymore than like four inches in everyday drive. I've seen that you seem to answer auestions pretty well on here and can you give me your opinion on what I've found with the paralell c- arms and should it be fine with a daliy driven truck. Again mad probs on some sick work! check out the courier on here lemme know what you think. 

yeah sound like it sound work fyour always going to get wheel sweep with the wheel moving up and down alot. but i have never had a problem on a daily truck like that.  anyways thanks alot for the comments here is a new pic of the rear end with the new wheels on it 22x10.5 running a 295/25x22 tire.

where the fuck is the wheel? lol looks sick

damn it tucks so much you cant eve tell what wheels are on it.  lol.  i miss my old ranger. an 87 was my first mini.  im gonna have to go build another one after seeing this one

well here is the frame as i am finishing it up the body will be at powder coat tommorrow and the frame by friday. the frame will be candy red the body will be candy black with red flake. finally almost all done with her. dont know if it will be done by the of noize show tho so might have to trailer it there. anyways thanks for the comments.

That is the coolest phucking frame I have ever seen! It's a shame that you gotta put a body on it