lowering my b2000 noob

Flat ones will work just fine bro. The angle blocks are to "try" and prevent from axle roll is all I believe. But on 3 inches I don't think you will have that problem. Otherwise if you do want them order them off ebay they have the complete kits for like 40 bucks shipped you should have them by next week.

Sweet! So removing the whole bump stop bracket is ok? Or just remove the rubber and the bracket is needed for some reason?

3in steel angled blocks with 2 inner leafs out! Im thinking the front needs 2-2 1/2 inches lower! How many splines on the front should i go? Thx again everyone. Its looking better

another side

Damn looks good bro! Well most do 2 splines and it's close to touching the tire so 3 should tuck some tire. And yes remove all the bump stop you really wouldn't need the bracket but a lot of guys just cut out the rubber either way works man.

What size are your tires man? You may have to roll your front fenders a little bit if you do tuck but that is super easy, just use a baseball bat and angle it on the top of your tire against the fender and roll around the top of the tire back and fourth until it rolls in and presses out a little bit and your tire should clear it fine. But maybe you won't have any issues. I would think 2 splines would make it pretty close to level. if it doesn't go low enough then go 3 it doesn't take long to do it maybe a half hour or so.

205/75/14 Ya the front took 1/2 hour,dam its so easy. Did 2 splines. Took bump stops out, something bottoms out if i push on the front end down, 1/2inch until something hits,maybe shocks? I havent checked it out yet! The beer got in the way! I will post another pic

Man just lowering it makes it look 1000 times better lol Whats next Limo tint all around,or no tint? Trying to figure out if it will look good? Also a 4in or 5 in block would have been more my style

tint the back window only. and yes your shocks are probably bottoming out.

Only the back? Hummmmmm