motor un-install

i got the motor bolted in finally and my header on!! i finally feel some relief, i just need to take off some small stuff get it cleaned and powder coated.. get my core support straightened out... hopefully it will all go well... everything has so far.

Look's good did u get your adapter for the carb already???

nah, im still waiting. it said 1-2 day shipping. so i guess tomorrow or wednesday. i found out my deal with the motor mounts... all i had to do was take them off and put them on the block, they would've fit fine... so b2000 and b2200 are the same... you dont have to switch anything... except for the distributer..

How long till she's running???

i tried today, and nothing. anyone know what i should look for to get her to fire up? it will crank over but not fire. my plugs and all are right, all connections are there...

To make it run u need to make sure u have Spark,Fuel & o2. Check that the plug wire to the blaster coil is on tight is it isn't the motor will turn but not start. Pull the first plug and make sure your getting spark.

i go tspark and all... it cranks a couple times then has a hard time cranking.. like the battery is goin to die, but it doesnt.

Get a new battery, or take your battery to advance and have them charge it. Make sure your timing is right get a light and check it. You could be a 180* out.

ok, i threw some gas in the carb, put my jumper cables on it... it seems like it wants to, i dont have my exhaust on it, lol just the header, it sounds like it is going to be LOUD!! its almost there, im letting it charge up now... hopefully it will crank

WOOOOOOOOO HOOOOOOOOOOOO it started!!!! man was it loud, sounded like a drag race motor with no exhaust... my garage is msokey is shit but i dont give a hit it started and ran lol, i revved it up.. it was louDDDDDDDDDDDDD!!!