Using stock maz a/c compressor for edc

ya i went to the back of my schools auto shop and was like damn a sanden 508 fuck ya and snagged it and what could i use after the comp? cause im kinda doin this on a budget

brake line. . . from an auto store. . .

I used 3/8". . .

-Josh

sounds good thnx for the help man really appreciate it. if i have anymore questions i know who to ask

did you run a checkvalve aswell?

You have to cuz the ac comp will et air out fast if its not on.

ok just makin sure.. and bodied b2600zx how much brake hose did u

I used 9' total. . . It reached jus over the rear axle. .

And yes. . definately a check valve. . I forgot that because I don't have one . . . But no worries. . Its fast enough to pump it back up haha But if I was usin if for suspension and not just a horn, I would definately run one! !

-Josh

I just did one on my truck ill try and get pics. I dont run oiler i just use greese and it dont get super hot but does get warm. I only ran 2' hydrolic hose to the air dryer then reg 3/8 plastic push lock on the other side of the filter. Then a check valve at the tank. I think the greese keeps it cooler, about 50 pumps on the greese gun i ran it alot and the air dryer is pretty clean still.

where did you get the hydro line

we need a tech write up on the grease conversion and a diagram for the lines from pump to tank and such. how did you go about wiring it up? all i have is one wire coming off my pump. my pumps a sd-708. what all could this set up be used for besides air horns and bags??? could you do old skool air shocks in the back?