Torsion Bracket Question

well i am starting to get the front brackets on finally, and i have everything cut away on the lower arm and the frame is cleaned off of all the bumpstops and what not.... i put it all together and jacked it up till it started binding and lifting the truck, and i still had about 2" before the frame would lay....any suggestions??

Flip the balljoint and piecut the upper arm maybe. You may also have to trim a little off the lower arm if it hits the frame. I don't remember if Doug had to do that on mine or not.

exactly how do you pie cut the arms..i guess im a lil confused on it.. and the balls are flipped..

T

Like this, this is robbie's build up in the photopost section, it starts on page 6, but this is the page that gets down to it.

i found out what is holdin me up

check it...

Sweet...yea Doug trimmed that on mine too. He added some plate after to strengthen it back up.

where abouts?? on the inside of the arm or did he plate the outside??

I'm pretty sure he plated the outside, maybe both. I'd have to look at it this weekend, I don't have any pics of it.

I cut that piece completely out....OH! I forgot that I have Custom Lower Arms!

Hope you get that thing bagged soon, good luck!



Dev

That helps