my 83 b2000 project

got the brass knuckles tacked to the shifter last night. i will post some better pics when i get it complete.

brosef what about that ashtray

damn bro. i keep forgeting. my fault. i will check tomorrow as soon as i get off work. sorry man.

Not a problem, and yes the setup on your shit looks alottttttt better.

started on the interior yesterday and was up til 3 this morning.

almost have the brass knuckles completely welded up and smoothed, sucks how 1 minute of welding turns into and hour of grinding. hmmm.




had to make new panels for the wall behind the seats, they will be getting rapped in black vinyl that i have laying around. i still have to make the kick panels and door panels. i will start on the kick panels today.



and finally, i got the seats out that someone installed. i went to install my bench seat and the rear bar hits the driveshaft tunnel. so i driled out the spot welds for the seat mounts and i am raising them up an inch with some 1x1 1/8 inch wall square tubing. i got all the spot welds welded back up and the 1x1 welded the the passenger side seat mount, now i have to do the driver side and get them installed. i still have to make some patches for the big ass holes someone drilled for the other seats.

Lookin good! Always fun havin to improvise a little (seat spacers). And I definately know what you mean about 1 minute of welding = many hours of grinding.

how the hell did you get that piece of trim out without tearing it to shit?

the one on the wall behind the seats? if that is the one you mean, it tore at the bottom corner but that was it. it was real wrinkled but i was real careful with them. do you need any? i can cut you out both sides if you need them.

got my bench seat installed tonight. i had to raise the mounts and inch to clear the driveshaft tunnel.

man ive been thinkin about puttin a bench in my ext cab. its different and would look pretty cool i think.






-justin