suicide doors project

well there not bolted down so i have to make a few adjustments with the brackets but that's about how they will sit. idk what you consider high or not there probably about average.

i put integra seats in my mazda and they sit the same as the stock bench seat did

i've put acura seats in mine and i'm working on a new mount and then the brackets that come off of the seats themselves i'm going to cut them and weld them back together so that they positioned closer to the seat.( brackets that are used to mount to tracks) in all i should gain about a total of an inch with what i've got setup.

hey wasn't saying anything bad bros like what he has going on alot. I was just asking as I have done alot of seat swaps and I like mine really low so I fit abit nicer in the truck I have found that the bench sits lower than the buckets so I try and keep everything low in the cab.

is it me or is one side of your truck lower than the other?

the passanger side sits a lot lower then the other side. no it wasn't just you. idk if that's just cause it's been sitting so long but i haven't started suspension work so that will be a big concern, hopfully it isn't too hard to fix.

its looking good

so i just got started working on my truck again and have a questions:

Where do i run my wireing on the door jamb??? i know which wires to use and where they go cause i straight wired them up and they work great, where should i drill the hole cause the door extends really far out and when closed the wires would be crushed, I know to use some type of rubber/plasic outer casing but i'm just kinda confused right now, if anyone has any suggestions that would be great.

i took some pics so if you could draw where to do it in paint that might help:

I have a kit that i will take picks of tomorrow and you will see how it works bro it is great just drill anywhere with this kit and the wires get run threw it and as the door open and closes the line moves in and out threw gromets you will get what I am saying when you see it and it is easy to get a hold of.

awesome, i'm deffinatly gonna do that, i didn't know they made something for such a thing, would an autoparts store carry it or if you wanna send me a link where i might be able to get one online.

that's exactly what i need!!!
:]]
thanks brah just post or message me some pics tomorrow or sometime this weekend would be great!!!