87 Mazda B2000 project, DONE!!!

not much of an update, but anyways... Got the rear framed cleaned up and picked up some more steel for the pump/ battery mounts. Also working on fiberglassing the "dash pad". Its the piece above the glove box. It is too soft to paint, plus it was cracked in 3 places. S o I fiberglassed it and will mud it up before it gets painted. Still working on the control arms...

right on

The start of the battery rack and pump mounts. It will hang from the rear frame rails.

very nice..

awesome, lookin good

subscribed!

Its going slower than I hoped for, but here are some more progress pics.


I made the upper control arms a little longer to try and get rid of some camber change. I want to be able to drive this truck low and not have a bunch of camber. It may make me have to get creative with the steering if the arm goes up that high. I won't know until I get the lowers made and cycle the suspension.

Ummmm... I have no idea how I have passed this build up but OMFG!!!!! I am not a fan of the three spoke...or should I say I WASN'T a fan. I think I ruined my shorts. Sick ass work man. I am now going to be following this bad boy. I may even pm you for some details on the frame notching, brackets, and raising the gas tank. I think that is an awsome setup.

haha nice setup man..

Thanks for the comments. I am getting ready to get this truck finished up. Hopefully it will be sooner than later.

rear cylinder mounts