project "cheap azz" update 1-6-12

ok got the frame z boxed and welded up





randy

looks good man keep up the good work and the pics rollin

ok got busy today and bagged the truck
the rear is a simple bag over axle until i figure something cool out
running the leaf springs and 3"blocks

front bag brackets i built out of flat stock
just tacked in to check fit and see if it layed out
getting everything out of the way

lower bag bracket

upper bracket with truck layed out
alignment of bag looks good nothing touchs

fully aired up bag still looks good not to much push out

body thrown together for a posture shot LOL
air up

layed out


lmao got a little crazy with the box side and pushed it out a little to far to fit the wheels 1/2 inch looks like a mile looks like truckarossa yuck
well back in the shop it goes to get blown apart again have to finish welding up all the bag brackets few gussets to add here and there also
hope to have all this stuff done by next weekend
then i can drop the new engine in it

looks real good

reverse 4 link, thats what im doing

And i have a question, idk y the front part of my truck wont lay out... the wheel wells are full cut out, im running re-7s, nothing is hittin or binding..im still only 3 inches from laying out the WHOLE front end...if u could, give me some advise..Thanks!

looks sick man! great work!!!!

very nice and quick progress

NEVER MIND.

Its only becuase of my freking stock tires are like 26"...once i get my low profiles, ill be fine

well did a few more thing to the mazda today

goof around with the wipers

did a mono wiper system on it and relocated the wiper motor so i could shave the firewall




here is a video of the wipers

Cool