***SkrapinSask from stock to layin frame***

Hauled the interior back home this evening and i hope to have it in by the end of the week after por15ing and seam sealing the firewall

good to see your still at it. Coming along nicely, now get it done!

Today the firewall was fully welded, painted inside the cab and seam sealed. Within the week i will have the interior installed once again. I have steam cleaned every clothe component as well as hand washed every single piece of the interior so its going to be like a brand new truck inside

Thanks for looking guys!

pointless to post progess without pics. pics or it didn't happen!!

Just imagine the last picture but painted black



Good friend burning the center seam. I'll be tossing the interior back in today after banging out a NASTY dent on the back of the roof near the window and this nightmare...

Keep it up man

Time to tackle the interior

best way to do the window is to start at one corner with pulling the gasket back. start working your way around a little bit and just push on the window and have somebody catch it on the other side. That simple haha










-Justin

Well some progress today!


unwrapped all of the interior i had boxed up from last summer


Used the Bissel little green to clean the seats up(still wet)


Getting there!

Does anyone remember if the ignition harness goes under or over the steering column before it connects to the wipers/signal control?

It'll feed up on the side of the wiper switch, and it goes over the column to plug into the back of the multi switch