1990 Mazda B2200 Is BodyDropped!!!

Ok so got the avs door poppers half installed

i just need to hook up the cables , the remote

do i need to take off the backing of the remote??
heres some pictures




Not sure what the purple and grey wires are for but i think the 2 white ones have to be hooked up to a parking light

ok so i want to get my steering wheel hooked up i called them at lecarra and she said she wasnt sure which one i needed?

if i go to this link
would it be the first one ? 3 to 9 bolt grant universal Part # 13290
because my steering wheel is for a grant column

your shocks may just be shot .. and when you lower a vehicle you need to put drop shocks . they run about 32.99 each cause your travel is shorter then before.. which means the strut in the shock will bottom out if its the o.e.m one to the truck.. change them to the drop shocks you'll notice a better ride with them . i know i did when i changed the shocks on my mazda.

ok guys so i bent the $*** outta my torsionbar bracket i accually lost one side and the others bent to shit the cop told me lastnight my trucks was to low what can i do ?? im only running a shock in the front no spring and a torsion bar without the torsions the trucks about 1/2" away from rubbing in the wheel wells i have full turning radious still any suggestions?

Well i canceled the insurance and starting to work on the front end of the truck.
i cut out the inner fenders ?? and wheel well in the passenger side. tommorrow im off so im going to cut out the wheel well on the drivers side. i also took the wiring harness for the lights , windsheild washer fluid , brake booster and all that and put it on the outside of the inner fenders, still needs finishing pictures when its done

wow doing alot I thought you were bringing it up here this winter bro.

My buddy has a garage with a welder and torch cutter so i dont need to take it anywhere but it was raining today and i didnt make any progress

Ok so the truck is now at my buddies garage for the winter. So far we have removed the bed,hood,wiper cowl,fenders,bumper,grill cut out the passenger side wheel well (95% done) and we have started a little bit on the driver side. Pictures soon

I beleive the plans are to get triangulated control arms with s10 ball joints for up front to get some negative camber and to allow the re7s to mount properly without having to notch the frame. Will the c-arms make the rims stick out more in the front ?

the cando arms do not change where the rim sits out from but if you do drop spindles then your wheel will sit out 3/4 inch farther out.

No i dont want them out more lol so drop spindles are not necessary with triangulated control arms unless i want my tires sticking out more? and where do u reccomend purchasing my control arms (lowest price )